Product Description
400 Series Cable Stripping Tool.
All-In-One Combination Prep Tool for prep of all 400 series cables for crimp or clamp connectors. Works for virtually all connectors on 400 cables such as SC400, Wilson400, LMR400, etc. Times Microwave CST-400 or CST400. SureCall Part # SC-400-PREP or SC400PREP. UPC: 854328008190.
Times Microwave combination manual cable preparation tool is made for use with 3/8 inch LMR-400 type coaxial cable using crimp and clamp-style connectors. This cable hand prep tool joins a cable stripper tool and a cable trimming tool into one easy-to-use device. Designed, assembled and tested in USA.
Prepare 400 series coax cable in two simple steps. First, insert the cable into side one, twist, cut, and expose the center conductor. Second, flip the tool around and insert the cable into side two. Twist and turn to expose the coax braid. This cable preparation tool has a built-in deburr tool and works with nearly all SC-400, Wilson-400, LMR-400 and similar type cable connectors.
Note: For any signal booster to help, outside signal strength must be at least -110 dB or there must be a clear line of sight to a cell tower that is within twenty miles. Before ordering, please check outside signal level in decibels or ensure that you can make and hold a phone call at any good spot outside where you can mount an exterior antenna. Square footage stated in signal booster listings is based on good signal outside. If it is any weaker, the boosted sq. ft. area will be considerably lower, accordingly.
Kevin K. of Anderson, California gave the following review:
Website is easy to use with plain straight forward info but could have had more on testing signal strength to make sure you get a strong enough booster.
Therefore, please note that stated sq. ft. coverage is based on good signal outside. For best results: If outside signal is weak, we suggest choosing the next higher sq. ft. coverage kit. If outside signal is very weak, we suggest choosing the kit with even more higher sq. ft. range bracket. Basically, higher the sq. ft. bracket, the more powerful the signal amplifier with greater Gain as well as higher uplink and downlink output power.
If outside signal is too weak (weaker than -110 dB), submit request for cell coverage solution assessment. Upon receipt of questionnaire, we will perform residential or business site survey. This will help us determine the system that is needed to improve cell coverage. Then, we will create system design using that system such as femtocell, active or hybrid distributed antenna system (DAS), or other carrier feed signal enhancing method available that will work at your signal-challenged location. Finally, we will schedule for installation after equipment and installation service quote has been approved by you, or your company.
For non installation-included kits: Most home / office / building cell signal booster kits only include bracket to mount exterior antenna on outside wall, edge of roof, or existing pipe up to 2 inches in diameter. Mounting pole not included with most kits, unless stated specifically that it is included for free. Therefore, a mounting post must be purchased separately if you will require it to mount exterior antenna.
![]()
