Antenna Roof Mount (Non-Penetrating)
Antenna Roof Mount (Non-Penetrating)
Buy Now, Pay Later with No Interest if paid in full within 6-12 months. Choose Klarna payment option at the checkout for details of this, and other long-term low-interest financing options.
Free Lifetime Support. SKU / Model: FRM125AFC
- Questions & Answers
- Data Sheet / User Guide
- Make An Offer
Looking for no penetrating mount? This is a non-penetrating roof mount and also a ballast roof mount offering 30 inches to 60 inches mast in sizes ranging from 1-1/4 inch to 2-3/8 inch outside diameter (OD).
The base of the ballast roof mount is 34-3/4" square with trays to fit the concrete blocks, for ballast mount.
The Rohn FRM125-AFC roof mount is hot dip galvanized for corrosion protection and goes together quickly.
Additional features include:
- No penetration on roof surface.
- Galvanized for corrosion protection.
- Designed for concrete block ballast mount.
- Assembly is quick and easy.
- Minimum of bolted connections.
- Optional roof pads or mats are available.
The FRM-Series is a non-penetrating roof mount for Direct Broadcast Satellite, off air antenna, satellite internet systems and point to point CCTV signal transmission. Using standard 8" x 8" x 16" cinderblocks as ballast, the FRM 125, 166, 200, 225, 238, 238HC and 238SP5HC provides a durable and reliable mounting platform to mount your equipment, without damaging your roofing surface.
- For use with DBS, off-air antenna, satellite internet systems and point to point CCTV signal transmission.
- Galvannealed steel construction.
- Holds up to eight 8" x 8" x 16" standard concrete blocks to anchor.
- Dark gray weather resistant powder coat finish.
- Read data sheet for more benefits and details.
Questions & Answers
QUESTIONS & ANSWERSAsk a Question
Is there a standard wind loading rating for the masts with various antenna configurations and ballast?
Unfortunately, your question does not have a definitive answer for it is relative to the weight of the item(s) mounted on the mast and where on the mast the item(s) are located. Please see the non-penetrating roof mount data sheet showing a chart for reference to the answer to the question. It should be noted that more bricks can be added to the sled in order to add weight to the low center of gravity.
Data Sheet / User Guide
Make An Offer
Note: For any signal booster to help, outside signal strength must be at least -110 dB or there must be a clear line of sight to a cell tower that is within twenty miles. Please check outside signal level in decibels before ordering. Square footage stated in signal booster listings is based on good signal outside. If it is any weaker, the boosted sq. ft. area will be considerably lower, accordingly.
If it is too weak, submit request for cell coverage solution assessment. Upon receipt of questionnaire, we will perform residential or business site survey. This will help us determine the system that is needed to improve cell coverage. Then, we will create system design using that system such as femtocell, active or hybrid distributed antenna system (DAS), or other carrier feed signal enhancing method available that will work at your signal-challenged location. Finally, we will schedule for installation after equipment and installation service quote has been approved by you, or your company.
Please note: Most home / office / building cell signal booster kits only include bracket to mount exterior antenna on outside wall, edge of roof, or existing pipe up to 2 inches in diameter. Mounting pole not included with most kits, unless stated specifically that it is included for free. Therefore, a mounting post must be purchased separately if you will require it to mount exterior antenna.