500 ft. Roll of RG11 Coax Cable with No Connectors | weBoost 951155 by Wilson Electronics / WilsonPro.

RG-11 low loss coaxial cable (75 Ohm) in spool, bobbin, cylinder or reel on which 500 feet of wire is wound is black in color. It does not come with any connectors on both ends. These're for indoor/ outdoor cable connections between signal amplifier to both inside or outside antennas. These're cables and adapters like regular TV or video cables typically found in homes.

This is an ultra low-loss coaxial cable made by weBoost / WilsonPro (both have same parent company, Wilson Electronics). It has practically the same minimal signal loss as the standard LMR-400 cables. It features 2/3rds the loss of RG-6 cables (less than 65% of the signal loss of a standard RG6 cable). It is great for connections between an amplifier to both indoor and outdoor antennas, taps, splitters or lightning surge protectors.

This cable has 13/32 inch diameter. It incurs around 1-2 dB of additional loss per 100 feet of cable. Please note that 75-Ohm cables cannot handle as much mobile data traffic as 50-Ohm cables. Therefore, in high user situations, you may see a reduced data speeds. This low loss foam cable can be used both indoors and outdoors with connections between amplifiers and antennas, taps, splitters and lightning surge protectors.

Coaxial cables form an integral aspect of cell phone signal booster installations. Cables run from donor antennas (outdoor antennas) to signal amplifiers, and then connect to antennas inside (broadcast antennas) to distribute the boosted signal. Connectors join the cables using male to female adapters (not included). Connectors link cables between signal meters and outside antennas, and come in handy whether making wireless signal readings or installing a new system.

For parts and accessories like this, you can count on SignalBooster.com. Perform a search at this website for F-Male connectors you will need, as well as RG-11 stripping tool and a RG-11 crimper to get the job done perfectly.

What can the maximum length of cable be?

Generally, SignalBooster.com recommends keeping the length of coax cables at or under a hundred feet total from wireless signal amplifier to inside or outside antenna. However, this depends on the strength of signal outside, the loss incurred in the type of coaxial cable being used, the loss through splitters and / or taps, and how much coverage space would be needed. With a good outside signal, higher quality cables, and higher-grade amplifiers, there're plenty of ways to be able to have longer cable runs. For example, if you have a strong outside signal of -40 dB, you can consider a cable run of around 155 feet from donor to amplifier and still have plenty of signal for the cell amplifier to work with.

How do I terminate RG11 cable?

You will need a RG11 stripping tool and a RG11 crimper to do the job right. Some dikes or a cutting tools are also a handy tool to have around for the task.

First take the RG-11 stripping tool and line it up with the edge of your cable. Spin the tool around the cable several times. You will feel the stripper cut through the shielding as you spin it around the cable. Pull the stripping tool off and remove any remaining pieces that remain. You will be left with something.

Peel the braided metal shielding back so it looks workable. Make sure that no metal shielding makes contact with the center pin. Then slip the RG-11 connector onto the cable. Be sure that the pin from the cable is properly inserted into the pin already in the connector. If the pin is too long, trim from the cable pin and try again until it fits properly. Do not trim the pin of the connector.

Place the connector and cable into the RG-11 crimper and crimp down firmly, bouncing the crimper a few times to ensure you have got a solid crimp. That is it. Now just measure out your cable to the proper length and repeat the process on opposite end.

Specifications: